H3C及CISCO的端口快速转发

https://www.h3c.com/portal/Technical_Support___Documents/Technical_Documents/Switches/H3C_S5600_Series_Switches/Configuration/Operation_Manual/H3C_S5600_Series_OM-Release_1602(V1.02)/200907/641497_1285_0.htm

H3C stp默认没启用

启用stp后，若某端口需要快速转发,则需要:

stp edged-port enable

Configuring the Current Port as an Edge Port

Edge ports are ports that neither directly connects to other switches nor indirectly connects to other switches through network segments. After a port is configured as an edge port, the rapid transition mechanism is applicable to the port. That is, when the port changes from the blocking state to the forwarding state, it does not have to wait for a delay.

You can configure a port as an edge port in one of the following two ways.

Configure a port as an edge port in system view

Follow these steps to configure a port as an edge port in system view:

Configure a port as an edge port in Ethernet port view

Follow these steps to configure a port as an edge port in Ethernet port view:

On a switch with BPDU guard disabled, an edge port becomes a non-edge port again once it receives a BPDU from another port.

You are recommended to configure the Ethernet ports connected directly to terminals as edge ports and enable the BPDU guard function at the same time. This not only enables these ports to turn to the forwarding state rapidly but also secures your network.

Configuration example

# Configure GigabitEthernet 1/0/1 as an edge port.

1)        Configure GigabitEthernet 1/0/1 as an edge port in system view

<Sysname> system-view

[Sysname] stp interface GigabitEthernet 1/0/1 edged-port enable

2)        Configure GigabitEthernet 1/0/1 as an edge port in Ethernet port view

<Sysname> system-view

[Sysname] interface GigabitEthernet 1/0/1

[Sysname-GigabitEthernet1/0/1] stp edged-port enable

cisco:

开启portfast